Instructions

1. After downloading the folder, unzip it and place the files that are in the folder onto USB key
2. You should now have two files (not inside any folder) on your USB key:
   pictures and database.vrp
3. Insert the flash drive into the USB slot on your engraving machine.
4. On the screen, press the settings button ⚙️ at the bottom left of the screen.
5. You will see one of these two screens.
6. If you see the SCREEN 1, please enter this password: 09876
7. Press “UPDATE“
8. Click the arrow to proceed. The update will begin and take up to 20 min.
9. Once the update is complete, remove the USB flash drive.